Most homeowners believe that plumbing repair is tough. It is easier if you have the proper knowledge and advice to do this job. There is some handy advice here that will get you on the right track with your plumbing needs.
Rigid copper is used for main water lines in many homes. You cannot bend rigid copper, so joints and tees must be soldered on. When soldering, always apply flux (also called soldering paste) to both surfaces. Flux retards oxidation when the copper is heated. Always use lead-free or nearly lead-free solder when sweating a copper joint.
To avoid clogs, pay attention to what you flush. Sanitary napkins, thick toilet paper and baby wipes should never be flushed. These items can expand and cause a clog, or get caught on a pipe. Instead, dispose of them in a sanitary way that does not involve flushing them down the toilet.
Make sure everyone that lives in your house knows where to find and use the main water shut off valve in case there is a burst pipe emergency. This is especially important if you live in an area where your pipes may freeze. Take a moment to show your family members where the valve is and how to properly shut it off.
Run cold water in your sink when you turn on the garbage disposal. Using cold water not only preserves the sharpness of the blades, but also makes the disposal process itself smoother. Hot water is not recommended because of what it does to greasy products.
Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.
Always keep your garbage disposal clean. You can do this in many ways. Pour some dish soap in and let the disposal run for a few minutes with some cold water. Be sure to run it regularly, if not, it can cause rust. To eliminate foul odors, grind lemon or other citrus peels. You can clean the walls of the disposal by grinding small fruit pits or egg shells.
Make sure you get a good recommendation or check the references before you hire a plumber. With good recommendations, it will assure that you are hiring an experienced plumber. If the experienced plumber is professional, he will have a fully stocked truck and be able to complete most small jobs in one visit.
As was discussed at the beginning of the article, while plumbing can be an extremely difficult chore for anyone to complete, it becomes significantly easier if you have the right advice and information. Use the advice from this article, and you’ll be on your way to doing your own plumbing.